Got a Voit Swimmaster off of fleabay, looking to use it as an octo on a project double hose. This is the first one I've torn down, when I got it apart the LP seat looked like it was made of a hard white plastic, but it was obviously deteriorated beyond reuse. I chipped out the plastic to see if a replacement soft seat could be put in there, it may work, just curious as to if this will work and hold up over time. I was very impressed with the "flippable" volcano type orifice on the LP inlet where the hose connects, it shows foresight on the part of the Voit designers. The reg is out for chroming along with a DA Aquamaster I picked up, both should clean up nicely.
Anyway, what is everybody using for LP seats on the Swimaster regulators these days?
Thanks,
Mark