Fairly last minute....Luis finally nagged me enough.
I should have some photos for you this afternoon on that related project.
Moderator: luis
Thank you.. ..I'll sleep better at night once I can check that off the list!!Herman wrote: I should have some photos for you this afternoon on that related project.
Looks like a winner of a double hose regulator. Can't wait to see final results on the test dives. Might even convince me to shelf my Royal Aqua-Master/Phoenix set up for a Argonaut from Vintage Double hose.Bryan wrote:Sorry about that....Had not heard that you decided to go for sure!Herman wrote: Make that 7 if you did not include me.
Automan wrote:Will you be offering a version with 300Bar (4300PSi) DIN tank connection rather than 232Bar (3300PSi) Yoke?
No DIN is planned.
Also will the Yoke clamp fit over the valve of a DIN valve scuba tank with a Yoke adapter in it?
The few that I have tried it on seem to work fine.
Also, are you going for EN250 approval?
No
The Conshelf DIN conversion will fit the Argonaut and the Aqua Lung Titan can be adapted to fit. Both of those fittings can be obtained from an Aqua Lung dealer.Automan wrote:Will you be offering a version with 300Bar (4300PSi) DIN tank connection rather than 232Bar (3300PSi) Yoke?
Return to “Phoenix and Argonaut Specialty Area”
Users browsing this forum: No registered users and 231 guests