Conshelf XII adjusting screw
Moderator: Greg Barlow
-
ubxdiver
- Diver
- Posts: 23
- Joined: Sun Aug 26, 2012 4:22 pm
- First Name: John
- Location: Virginia
Conshelf XII adjusting screw
I've got a Conshelf XII with an 3/8" Allen Wrench intermediate pressure adjusting screw. When did the adjusting screw change to a slot screw?
-
Bryan
- Plank Owner
- Posts: 5279
- Joined: Fri Jun 24, 2005 11:40 am
- First Name: Bryan
- Location: Wesley Chapel Florida
- Contact: Website
Re: Conshelf XII adjusting screw
When Aqua Lung ran out of hex head adjustment screws
Doing it right should include some common sense, not just blindly following specs and instructions. .Gary D, AWAP on SB
-
rhwestfall
- Master Diver
- Posts: 639
- Joined: Thu Jan 16, 2014 2:34 pm
- First Name: Robert
- Location: "La Grande Ile"
Re: Conshelf XII adjusting screw
that was just plain funny....
Bob
No Longer Awaiting my Kraken.....
No Longer Awaiting my Kraken.....
-
Ron
- Site Admin
- Posts: 1758
- Joined: Mon Oct 20, 2008 5:51 pm
- First Name: Ron
- Location: Puget Sound, Washington
- Contact: Website
Re: Conshelf XII adjusting screw
This is anecdotal, but I've had tons of conshelves over the years and the changeover point appears to be between the XI and XII. I've seen XI's with straight slot or hex adjusting screws, but all my XII's had straight slots. So...1971 ish.
The impossible missions are the only ones which succeed. -JYC
-
ubxdiver
- Diver
- Posts: 23
- Joined: Sun Aug 26, 2012 4:22 pm
- First Name: John
- Location: Virginia
Re: Conshelf XII adjusting screw
Thanks Ron
Return to “Single Hose Regulators.”
Who is online
Users browsing this forum: No registered users and 5 guests