jvanostrand
Diver
Posts: 21
Joined: Fri Aug 12, 2011 8:39 pm
First Name: John
Location: Waterloo Ontario

Is this a liner?

Thu Jul 21, 2022 11:07 am

I picked up a pair of Wallter Kidde 38s, stamped 1963. With 3/4-14 pipe threads I'm hoping to reuse these tanks for sidemount. They appearsto have a liner. It's not the kind I've seen in the past though. Is this plastic,, epoxy, or paint? Is a tumble the only way to remove it? Would any chemical treatment work. like paint stripper?
There's a local fire services guy who will tumble and hydro for $100. It seems like a lot.
PXL_20220719_152008779 (1).jpg
IMG_20220719_112356 (1).jpg
You do not have the required permissions to view the files attached to this post.

User avatar
captain
Plank Owner
Posts: 1433
Joined: Mon Jul 04, 2005 11:32 am
Location: LaPlace, LA

Re: Is this a liner?

Thu Jul 21, 2022 11:20 am

Looks like it's lined. One type was off white another was brown, in both cases I believe it is an epoxy. Having a liner doesn't automatically disqualify a tank from being hydroed. Just as rust presents it's self as bubbles or blisters in a cars paint the same applies to a tank. A good visual inspection should determine if it needs to be removed before the hydro. I have had lined tanks hydroed.
Captain

User avatar
luis
VDH Moderator
Posts: 1723
Joined: Thu Jun 30, 2005 9:28 pm
First Name: Luis
Location: Maine

Re: Is this a liner?

Thu Jul 21, 2022 10:49 pm

From the picture that looks like the white liner I have in a few of my tanks. Because of the white liner reflects light so well, it is very easy to see any imperfections.

I have one that is perfect with no imperfections.

Another one I have had a few rust spots, but they all polished out with a whip/ wire spinning brush on a drill. The coating is thin enough that if any rust gets under the wire brush just cut the coating and cleaned the rust. The rest of the coating where it was firmly attached tot the base steel was not affected.

I have never tried to remove all the coating, there is no point. At least with the type of coating on my cylinders it is easy to inspect for rust (blistering) and it has been hard to remove the imperfection.

With some of the thicker coatings the situation may be different if you see any blistering due to rust.

I would not remove the coating unless there is a definite need due to rust under it.

BTW, the dark spots looks like someone tried already to remove the liner, but as long as it is smooth and well stuck to the steel, it is hard to remove.

Good luck
Luis

Buceador con escafandra autónoma clásica.

Return to “Tanks and Valves”

Who is online

Users browsing this forum: No registered users and 28 guests