Forum rules
Regulator specific information can also be found on the main page of the website in the Regulator Id Guide.
User avatar
Plank Owner
Posts: 5270
Joined: Fri Jun 24, 2005 11:40 am
First Name: Bryan
Location: Wesley Chapel Florida
Contact: Website

Mar-Mac banjo info

Wed Sep 12, 2007 7:10 pm

Works with all short yoke USD and Voit Double Hose Regulaors……All you do is screw on your pressure gauge and slide the Mar-Mac banjo (O-ring on the banjo facing the regulator) between the cylinder valve and the regulator. Tighten it down a little more snug than you usually would and you are good to go. DO NOT OVERTIGHTEN…..The Mar-Mac banjo works best on the early type valves with the full sized O-rings on them (see pictures) It will work on some of the later types but I have found they tend to leak a lot when you use them with the thermo/blue steel/ DIN insert type valves. Hope this clears things up.
Doing it right should include some common sense, not just blindly following specs and instructions. .Gary D, AWAP on SB

Return to “Technical Information / Diver Training Information”

Who is online

Users browsing this forum: No registered users and 0 guests