Barn find... Builds pressure quickly. Seems around 2.5 CFM. 3000- ish...
Bauer:
Model? Manual? Parts (future)?
I have a real nice filter stack for it, so that shouldn't be an issue...
What else should I know?
Moderator: captain
Wow, that's a heck of a nice find. Low RPMs, probably quiet and will last forever. Then I was looking at the specs above and wondering if it could go higher than 2200 psi. The plate on the identical compressor in the link says 225 atu... I looked up atu units and it is either atmospheres or BAR in modern measurements... Which puts it in the 3,000 + psi capability. Bill, on this grade of compressor, is there an acceptable way to pump higher 2200 psi pressures? On the other hand, I dive steel tanks marked from 1800-2250... This compressor will pump up everything I dive just fine! Congrats on a heck of a nice compressor!rhwestfall wrote: ↑Sat Aug 25, 2018 3:46 pmThe plate on the skid:
MAKO
K-18
2.1 cfm
2200 psi
750 rpm
SN: 4652
Motor is a GE
1.5 HP, 120/240 single phase w/ 220 plug
1725 RPM
Users browsing this forum: No registered users and 7 guests