Well after looking through the catalog link that Tom sent me and some searching on the net I reached the conclusion that I would probably not find another toggle switch to install in this compressor that would mount to the compressor the same way as the original with the 2 mounting screws. That being the case I decided to make a trip to my local True Value Hardware and see what I could find there. I found a Gardner Bender model GSW-14, 20 amp switch that would do the job and it did have 4 screw mount terminals just like the original switch. The only difference was how it was installed in the compressor. Instead of using the 2 mounting screws like the original I just slid the post through the hole in the compressor base and then secured it with the circular nut. Overall it was a pretty easy procedure; all I had to do was drain the oil from the compressor so I could tip it up, remove the bottom cover, remove the old switch and then install the new one. I then reassembled, put the oil back in and fired her up - works just fine. Thanks again for the info Tom!
The friendship of many has been inspired and created while together we've explored beneath the waves the wonders of God's creation.
NAVED Member #137
Member of The 2016, 2017 Sea Hunt Forever Dive Team