Fri May 05, 2006 11:34 am
I thought the same as you at 1st Luis....Till I sent one of these seats to a customer thinking it was a DA seat and THEY told me that it would not fit in their DA....I then tried them myself and the customer was right. The OD of the square will not allow it to go in ANY DA nozzle that I had......I sure hope we can find out what they go to as there could be some regulators that are not in service that need one of these seats!
Doing it right should include some common sense, not just blindly following specs and instructions. .Gary D, AWAP on SB