User avatar
Posts: 18
Joined: Mon Jul 10, 2017 9:42 am
First Name: Dave
Location: Hamilton, Ont

DA navy approved horseshoe seat

Mon Mar 23, 2020 7:01 pm


I’am in the slow process of restoring a DA Navy, and am trying to replace the LP seat on the horseshoe, was looking for any help or advice on how to remove and replace

You do not have the required permissions to view the files attached to this post.

User avatar
Master Diver
Posts: 1579
Joined: Thu Apr 08, 2010 11:25 am
First Name: Mark
Location: Laguna Beach, CA

Re: DA navy approved horseshoe seat

Mon Mar 23, 2020 9:03 pm

Hi Dave, I replaced that seat on my Voit Mariner which is essentially the same horseshoe/seat as you have. The kind folks here walked me through the process.

Just use a brass pick to carefully pop out the old seat. You will see the holder is curved inward around the top to hold the seat in place. That is the only thing holding the seat in place. I was advised to put a drop of superglue in when I popped in the new seat and it worked great. Not sure its necessary. My 2psi. Good Luck!
"The diver who collects specimens of underwater life has fun and becomes a keen underwater observer. .. seek slow-moving or attached organisms such as corals, starfish, or shelled creatures." (Golden Guide to Scuba Diving, 1968) :D

Master Diver
Posts: 395
Joined: Sat Jul 02, 2005 12:45 am
Location: Minneapolis

Re: DA navy approved horseshoe seat

Tue Mar 24, 2020 11:32 pm

Dave the same as I suggested and used on my Voit Mariner and da regs.Have fun tuning it!

Return to “General Discussions”

Who is online

Users browsing this forum: No registered users and 9 guests