USD Hourglass mouthpiece

[Drado]

Ever since seeing this mouthpiece in Yank's photos from Jig's thread, I've been jonesing for one on them. Since they seemed to be in very short supply, I decided to take matters into my own hands.

Since I've been using these mouthpieces for my PRAMs, it only seemed logical to put a USD logo on it (Voit lovers, avert your eyes!)





Took the logo off one of the "dead" curved rubber USD mouthpieces I had. Would've been a shame to cut up my good USN silicone mouthpiece for this project

How long will the modification last? Well, I only need it to last as long until the VDH DSV comes out - then my PRAM mods will be complete

[captain]

If it's your non mag it should say USN on it not US Divers.

[Drado]

Yup, but I didn't want to cut up my silicone USN curved mouthpiece.

[SurfLung]

- Pretty neat... I think if I tried that, I'd end up slicing through the middle of the logo!