Page 1 of 1
LP Hose ID Help Needed
Posted: Wed Jan 13, 2016 2:45 pm
by Bryan
I got all these hoses in a bulk purchase deal. I THINK the majority of them are DACOR. If anyone recognizes what they go to please post.
Re: LP Hose ID Help Needed
Posted: Wed Jan 13, 2016 2:46 pm
by Bryan
Second
Re: LP Hose ID Help Needed
Posted: Wed Jan 13, 2016 2:47 pm
by Bryan
Third..... DACOR 1987 retrofit
Re: LP Hose ID Help Needed
Posted: Wed Jan 13, 2016 2:49 pm
by Bryan
Fourth APEKS
Re: LP Hose ID Help Needed
Posted: Wed Jan 13, 2016 2:51 pm
by Bryan
Looks like the ends were added to these but all appear to be new FIFTH
Re: LP Hose ID Help Needed
Posted: Wed Jan 13, 2016 2:52 pm
by Bryan
One is Scubapro and a couple are USD if I remember correctly
Re: LP Hose ID Help Needed
Posted: Wed Jan 13, 2016 4:20 pm
by rhwestfall
yes, last picture - one on left is SP
last one, second to end on right is a dry suit hose, seen them somewhere lately, Trident?...
last picture, one on far right is IIRC, an old USD/AquaLung Horshehoe LPI....
fits this one:
(FWIW - if anyone needs one of the USD ones, I have one for the cost of shipping...)
Re: LP Hose ID Help Needed
Posted: Wed Jan 13, 2016 5:00 pm
by rhwestfall
check pages 42-42 & 78-79 of Trident 2016 Catalog, 73 for added on fittings,
Re: LP Hose ID Help Needed
Posted: Wed Jan 13, 2016 7:51 pm
by luis
Bryan wrote:Looks like the ends were added to these but all appear to be new FIFTH
These ones look like the DACOR QD on my Nautilus.
Re: LP Hose ID Help Needed
Posted: Thu Jan 14, 2016 9:34 am
by Bryan
luis wrote:Bryan wrote:Looks like the ends were added to these but all appear to be new FIFTH
These ones look like the DACOR QD on my Nautilus.
Good to know......There are folks attempting to use those things so maybe these hoses will help.
Re: LP Hose ID Help Needed
Posted: Fri Jan 15, 2016 2:08 pm
by rhwestfall
that "winged" DS hose - not sure who makes it, but it is being sold at ScubaToys....
Described as follows: The Drysuit Inflation Hose is a standard 31-inch Si Tech hose with a 3/8-inch UNF thread fitting for standard low pressure regulator ports. The Drysuit Inflation Hose uses a quick-release connector with wings on the sleeve for ease