Page 1 of 1
Need help with J-valve disassembly
Posted: Sat Nov 27, 2021 8:43 pm
by rx7diver
Members,
I am attempting to disassemble my just- purchased U.S. Divers J-valve. Quick question: How do I remove the internal brass "switch" reserve part? You know, that part that "clicks" on/off? (See 2nd pic.)
Thanks in advance.
rx7diver
J_Valve_20211127a.jpeg
Re: Need help with J-valve disassembly
Posted: Sat Nov 27, 2021 10:05 pm
by antique diver
Unless there is some corrosion in there it should come out with a little gentle help from needlenose pliers. If not, maybe a good soak in vinegar or CLR & hot water about 50/50 (not overnight... and hour or two should do the trick)
Good luck, and keep us posted on your results.
Re: Need help with J-valve disassembly
Posted: Sat Nov 27, 2021 10:55 pm
by ScubaLawyer
As I recall, it just sits in there.
Re: Need help with J-valve disassembly
Posted: Sun Nov 28, 2021 12:45 am
by antique diver
ScubaLawyer wrote: ↑Sat Nov 27, 2021 10:55 pm
As I recall, it just sits in there.
Yep, they usually just fall out.
Re: Need help with J-valve disassembly
Posted: Sun Nov 28, 2021 9:42 pm
by rx7diver
Yes, thanks, everyone. I posted this same question over on SB, and Luis H. suggested I gently use needle-nose pliers--which I did. The resistance I originally felt (before I posted yesterday) was due to some old and thickened grease that was packed around the spring of the reserve mechanism. I decided to ask before I forced things and ruined anything.
Everything is apart, and clean (I used 409 since I was out of Simple Green), and now ready to be reassembled.
Thanks again.
rx7diver