SurfLung wrote:Hi Jim,
Yeah, that flappy look has bothered me, too. I've thought of putting an idler wheel in there. The belt is actually very tight (I think)... I have a 3 foot pry-bar I lean on as I tighten the motor mounts. The top is the slack side when the compressor is running so maybe that's why it looks like that.
Here's the manufacturers info and schematic on the valve that you have mounted after your final separator on the compressor. http://valvesandregulators.aquaenvironm ... 20906R.pdfSurfLung wrote:- I'm wondering if my Back Pressure Valve (aka PMV) is working properly. When I don't have the hose connected to the filter array and turn on the compressor, there is airflow coming out. I thought it was supposed to have no air coming out until 1800 psi. BUT, when the hose is connected to the filter array, it does seem that the back pressure valve holds back until 1800 because that's when the needle starts to move on the filter array's gauge.
- However, I disconnected the hose at the BPV and there was some water in the hose. The filter array is located a couple of feet above the BPV so the water stays mostly at the bottom. But I'm wondering if there should be any water in there at all?
Don't tell me, "Fits like a glove!"SurfLung wrote:My RIX Purrrs...... So I got out my jig saw and cut that section out of the cowl. ....
Users browsing this forum: No registered users and 2 guests