Page 1 of 1
Argonaut Assembly
Posted: Sat Apr 30, 2016 1:28 pm
by Bryan
I had a little time to work on the blog today. I'll try to get the whole process documented before I start assembly on all the new ones.
CLICK HERE
Re: Argonaut Assembly
Posted: Sun May 01, 2016 9:16 am
by Bryan
Argonaut Kraken Main Body Assembly
CLICK HERE
Re: Argonaut Assembly
Posted: Mon May 02, 2016 10:58 am
by Bryan
Re: Argonaut Assembly
Posted: Mon May 02, 2016 12:43 pm
by rhwestfall
Thanks Bryan! BTW - with the amount of time, effort, and care you put into these, you don't make enough on these regulators (but thanks for pricing them where they are at
) Loving mine since the day I got involved in the project through the funding campaign!
Re: Argonaut Assembly
Posted: Mon Jan 14, 2019 1:29 am
by Chris
The orings on the screws, simply to make assembly easier, right? Just wanted to be 99% sure instead of 98%.
Re: Argonaut Assembly
Posted: Mon Jan 14, 2019 2:37 am
by Chris
Now that I think about it, I guess since the screws are non shouldered, and assuming the screws are not to be overly tight against a plastic can, the orings would help keep the screw from unscrewing if one came loose.
Re: Argonaut Assembly
Posted: Mon Jan 14, 2019 8:36 pm
by rhwestfall
IIRC, Luis hates losing/dropping small parts, so the captured screws were a best practice...
Re: Argonaut Assembly
Posted: Mon Jan 14, 2019 10:13 pm
by luis
The screws are to capture the screws. When you open the cans, the screws don’t fall off the front can.
I don’t like loose hardware.
Loose hardware = lost hardware.