DO NOT use locktite or any sort of thread locker on the screws. Torque them to 8"lbs or just a shade over two fingers tight gripping the screwdriver. There is zero lateral movement on the HPR.SnarkIII wrote: ↑Mon Feb 05, 2018 6:27 pmI'm doing my first Overhaul/Upgrade on a DAAM. I have the cyclone in and I'm ready to install the HPR. If I understand this thread correctly the HPR should be finger tight and backed off until aligned properly. When installing the screws that lock it in place the book says to use Loctite to hold the screws in place. I don't see any mention of Loctite in this thread. Is some type of thread lock required with the HPR?
Users browsing this forum: No registered users and 2 guests