Tue Jun 24, 2014 7:41 pm
It looks like it would be very easy to cut 4 slots in the center section of the BC to match the outer slots on the plate. It doesn't look like it would affect the integrity of the bladder as long as you stay inside the center section. You probably want to burn the edge of the cut with a hot knife or something similar to keep the fabric from unraveling.
I would call DRIS (Dive Right In Scuba) and ask them if there is any issues with cutting 4 slots in the center section of that BC. I have dealt with DRIS and they are very nice and very helpful.
The bladder looks good. It would look great if it had a smaller section across the top. I don't understand why they put so much volume on the top of those bladders.
In any case, if you tuck that top section of the bladder behind your DH regulator it works well. It works particular good behind/ under your Phoenix or your new Argonaut. The DH regulator will allow enough to the bladder for air to move from one side to the other, but it should control the top of the bladder from holding too much air and mess your horizontal trim (if you put that much air behind your head it will try to get you vertical).
Luis
Buceador con escafandra autónoma clásica.