Page 1 of 1
Need USD solid bar manifold part.
Posted: Sat Dec 13, 2014 8:38 pm
by ScubaLawyer
Hello all,
I'm overhauling a USD solid bar manifold. Anybody got a #7 (828510 Back-up ring)? It's a flat ring, not an o-ring. Thanks, Mark.
Aqua-Lung Valve manual late.jpg
Re: Need USD solid bar manifold part.
Posted: Sat Dec 13, 2014 9:21 pm
by Bryan
Re: Need USD solid bar manifold part.
Posted: Sun Dec 14, 2014 3:34 am
by ScubaLawyer
Unfortunately not - too wide, too thick, too white....
[Yes, I'm aware of the joke fodder this response gives - purely unintentional. Just trying to be descriptive.]
Any other ideas? Mark
Re: Need USD solid bar manifold part.
Posted: Sun Dec 14, 2014 8:16 am
by antique diver
Is the one from your valve the same size as the oring? If so, and yours is damaged you can get those from a local seal and oring supply house. If not damaged just lubricate it an re-use, but replace the oring. Another viable option that I have used is to use a second 010 oring there. If possible that one should be a 90 durometer hardness instead of the more common 70 d used for most of the orings.
I should have those orings, and maybe even the backup rings that size and will be glad to drop some in the mail if that's what fits... just let me know.
If all else fails send the valve to me, and I can try a combinations of seals until it works! It's not really complicated, and I can almost guarantee a quick fix and fast return. I will be glad to help.
Re: Need USD solid bar manifold part.
Posted: Mon Dec 15, 2014 7:34 pm
by kgehring
PM address and I will send you one.
Re: Need USD solid bar manifold part.
Posted: Mon Dec 15, 2014 8:47 pm
by ScubaLawyer
kgehring wrote:PM address and I will send you one.
PM Sent. Thank you. Mark