Page 1 of 1
Two Stage Cutaway
Posted: Tue Jan 22, 2008 12:33 am
by Bryan
Here is the 2 stage cutaway. This one is a Pico DA Aqua-Master. The 1st stage parts are identical in the Trademark, Broxton, DA Navy, DA Navy Approved and the DA Aqua-Master. The Royal Aqua-Master 1st stage is A WHOLE LOT DIFFERENT! As soon as I run across a RAM 1st stage that has a damaged volcano orifice I will cut it in half so you can see how it differs.
The DA Aqua-Master and the Royal Aqua-Master use the same 2nd stage assembly and parts as is shown on this regulator….The earlier regulators used a horseshoe lever assembly with two springs and a pin to pivot against and is completely different.
Photos are large and you can zoom in for detail….Sorry I’m not a better macro photographer. ENJOY!
CLICK HERE FOR PHOTOS
Posted: Tue Jan 22, 2008 11:15 am
by standingup
Again great shots -THANK YOU
Posted: Tue Jan 22, 2008 11:09 pm
by seakrakken
Thank you Bryan!
Posted: Wed Jan 23, 2008 8:26 am
by crimediver
Shazam!
Cut a ways
Posted: Thu Jan 31, 2008 12:39 pm
by 21
There were three in the set.. the missing one is the early single hose Calypso. The model with the metal mouth piece
The double hose also had the hoses attatched and cut a way to demonstrate the non returns etc.
I have all three..Tommy Thompson gave them to me. They had been made by US Divers as a training aid but just didn't sell. Too much $$$$???
The company that made them was a small machine shop in Fountain Valley who also made the Manta CO2 powered spear gun of the 1950s.
21
Posted: Thu Jan 31, 2008 4:03 pm
by 1969ivan1
Thanks for the rest of the story 21! I love this forum.
Re: Cut a ways
Posted: Fri Feb 01, 2008 11:17 am
by Bryan
21 wrote:There were three in the set.. the missing one is the early single hose Calypso. The model with the metal mouth piece
The double hose also had the hoses attatched and cut a way to demonstrate the non returns etc.
I have all three..Tommy Thompson gave them to me. They had been made by US Divers as a training aid but just didn't sell. Too much $$$$???
The company that made them was a small machine shop in Fountain Valley who also made the Manta CO2 powered spear gun of the 1950s.
21
Please send over the Calypso cutaway and a Manta speargun for good measure. I will take care of both of them for you.....
CUT A WAY
Posted: Fri Feb 01, 2008 11:53 am
by 21
Sure you will....
I just discovered I do not have the single stage reg--must have loaned it to my son...so how about sending yours to me and I will have a complete set...
FYI I also have three spearguns that were cut a way.. a JBL, Spear Fisherman (Swimaster) and a Arabelete (US Divers)...Strange the things that you aquire along life's path.
21
Re: CUT A WAY
Posted: Fri Feb 01, 2008 12:59 pm
by Bryan
21 wrote:FYI I also have three spearguns that were cut a way.. a JBL, Spear Fisherman (Swimaster) and a Arabelete (US Divers)...Strange the things that you aquire along life's path.
21
Ok, I'll take those instead......Thanks Dr. Miller!!