User avatar
antique diver
Master Diver
Posts: 2060
Joined: Sun Dec 10, 2006 12:50 pm
First Name: Bill
Location: North-Central Texas

High-Tech Regulator Tool

Wed Feb 19, 2020 10:23 am

Do you recognize this 70's special regulator tool sold by a Scuba manufacturer? I think even I could make one of these.
Reg tool.jpg
You do not have the required permissions to view the files attached to this post.
The older I get the better I was.

User avatar
Bryan
Plank Owner
Posts: 5270
Joined: Fri Jun 24, 2005 11:40 am
First Name: Bryan
Location: Wesley Chapel Florida
Contact: Website

Re: High-Tech Regulator Tool

Wed Feb 19, 2020 12:53 pm

Hi tech lever bending tool ?
Doing it right should include some common sense, not just blindly following specs and instructions. .Gary D, AWAP on SB

User avatar
antique diver
Master Diver
Posts: 2060
Joined: Sun Dec 10, 2006 12:50 pm
First Name: Bill
Location: North-Central Texas

Re: High-Tech Regulator Tool

Wed Feb 19, 2020 2:42 pm

Yep! You are the winner of a 007 Oring that I think will fit a Sherwood piston stem.

They actually made and sold these as the factory recommended means of adjusting the 2nd stage lever height. Funny thing is that it worked very well.
The older I get the better I was.

Return to “General Discussions”

Who is online

Users browsing this forum: No registered users and 11 guests